If you order your custom term paper from our custom writing service you will receive a perfectly written assignment on Aim: To investigate the effect of size on the rate of heat loss.. What we need from you is to provide us with your detailed paper instructions for our experienced writers to follow all of your specific writing requirements. Specify your order details, state the exact number of pages required and our custom writing professionals will deliver the best quality Aim: To investigate the effect of size on the rate of heat loss. paper right on time.
Our staff of freelance writers includes over 120 experts proficient in Aim: To investigate the effect of size on the rate of heat loss., therefore you can rest assured that your assignment will be handled by only top rated specialists. Order your Aim: To investigate the effect of size on the rate of heat loss. paper at affordable prices!
Hypothesis
Larger animals lose heat at a lower rate than smaller animals. As the organism gets bigger the volume and surface area ratio decreases. This means that there is less surface area to lose heat from. If we use penguins as an example, the larger penguins live closer to the poles that the smaller penguins. So smaller animals have a higher surface area to volume ration and larger animals are the opposite. As the size of the animal increases the rate f heat loss decreases. The rate of heat loss depends on the surface area to volume ratio.
The total heat production of 'warm blooded' animals- depends upon the volume of metabolically active tissues whilst the rate of heat loss depends upon the surface area. For this reason, animals living in colder climates tend to be large whilst living in a hot climate they are generally smaller.
This is known as Bergmann's rule and is observed in many species. The metabolic rate per gram of the smallest mammals is approximately 100 times faster than the largest.
Do my essay on Aim: To investigate the effect of size on the rate of heat loss. CHEAP !
They have a large appetite enabling them to maintain a high metabolic rate. Heat gain and loss depend on the ratio of the surface area to the volume (the Surface Area/Volume ratio) because heat is stored in the volume of an animal but gained or lost over the surface. The higher the Surface Area/Volume, the faster an animal can heat or cool. Since as animals get larger, the Surface Area/Volume gets smaller (Volume increases faster than Surface Area as animals get larger), large animals heat or cool more slowly than do small animals.
Length ofOne sideTotal surfaceAreaVolumeRatio of surface area to volume
16161
4848 = 1
547547 = 1
4664664 = = 1.51
5151515015 = 05 = 1.1
616611616 = 11
·radiation refers to light energy. Animals can gain heat from sunlight; they can lose heat as heat energy radiated away from their bodies.
·conduction refers to gain or loss of heat from one surface to another. Animals can receive heat from warm surfaces or lose it to cold surfaces.
·convection refers to gain or loss of heat to or from a fluid, such as air or water. Wind or water currents often carry heat away from animals; occasionally they can also bring heat to animals.
· evaporative water loss leads to heat loss when water evaporates off of the body surface of an animal because it takes energy to convert water from liquid form to gas form; this energy is lost from the animal as heat. Note that this only works if the water actually evaporates from the surface of the animal -- if it drips off, heat is not lost.
Method
Equipment list.
-Kettle
-Beakers
-Thermometer
-Clamp stand and arm
-Heat proof mat
-Stopwatch
-Water bath
I will use 5 different size beakers to represent 5 animals at different sizes. The boiled water will be measured and put into the beakers and the temperature recorded. A stopwatch will be used to time 10 minutes and every minute the temperature will be taken. For each beaker of water the experiment will be done twice to ensure it is a far test and see if the results match closely. The boiling water will be used immediately to prevent heat loss. My starting temperature will be 80 C.
Variables
Independent variable is the size of beaker and volume of water. I am using 5 different size beakers. Below shows some variables and how each of these influence my resl=ults also how I plan to control some of them.
Dependent variable is the rate of heat loss.
The control variables are to be kept constant to make it a fir test.
e.g. The thickness of the glass beakers so there is equal insulation. This could effect my results because if a beaker was thinner than the others then of course the heat would escape faster.
The same starting temperature of hot water. If this was not the same for each experiment then the results would not prove anything. Use a thermometer.
Constant ambient temperature. Keep the difference between 'body' temperature and environment the same.
Air movement to minimise heat loss by convection. Keep windows closed.
Heat proof mat to keep surface or conduction constant. Otherwise the heat would escape through conduction.
The results were as follows
Size of beakerTime/ minutesTemperature/ C
1st timeRepeat
1000ml01456781080 C7 C78 C76 C75 C75 C74 C7 C7 C71 C70 C80 C7 C77 C76 C75 C74 C74 C7 C7 C71 C70 C
500ml 1456781080 C76 C7 C71 C70 C68 C66 C65 C64 C6 C80 C77 C7 C71 C6 C67 C66 C65 C64 C6 C
400ml1456781080 C77 C75 C74 C7 C70 C6 C68 C66 C65 C80 C77 C76 C74 C7 C71 C6 C68 C65 C64 C
15ml1456781080 C76 C7 C66 C 65 C 6 C 60 C 5 C 57 C 56 C80 C76 C74 C70 C66 C6 C60 C5 C57 C56 C
50ml1456781080 C76 C7 C71 C68 C66 C64 C6 C5 C57 C80 C77 C74 C71 C68 C66 C64 C6 C58 C56 C
Rate of heat loss results are as follows
Rate of heat loss = Total drop in temperature/Total time
v1000ml
Rate of heat loss = 10 C/10min = 1 C/min
v500ml
Rate of heat loss = 18 C/10min = 1.8 C/min
v400ml
Rate of heat loss = 14 C/10min = 1.4 C/min
v15ml
Rate of heat loss = 4 C/10min = .4 C/min
v50ml
Rate of heat loss = C/10min = . C/min
I took all the measurements by having the thermometer in the water constantly and then every minute I took the temperature. I did two experiments at once to save time, and then I repeated them for a fair test.
Please note that this sample paper on Aim: To investigate the effect of size on the rate of heat loss. is for your review only. In order to eliminate any of the plagiarism issues, it is highly recommended that you do not use it for you own writing purposes. In case you experience difficulties with writing a well structured and accurately composed paper on Aim: To investigate the effect of size on the rate of heat loss., we are here to assist you. Your cheap custom college paper on Aim: To investigate the effect of size on the rate of heat loss. will be written from scratch, so you do not have to worry about its originality.
Order your authentic assignment and you will be amazed at how easy it is to complete a quality custom paper within the shortest time possible!